wiki:public/doc/by_ext/ic/S_geo_type
Last modified 3 years ago Last modified on 08/05/15 09:23:06

Description

The input of IC has been prepared for 1D, 2D and 3D models and allows to assign initial conditions to the whole 1/2/3D domain (see Example 1), along predefined surfaces or polylines or by a list of points.

Parameters

The parameter is defined in subsequent line below the keyword. Example 1 shows an IC file for a model-wide equally distributed constant hydraulic head. The parameter DOMAIN is used to assign values equally over the whole domain. The following geometry types are supported:

  • POINT gli_point_name (assigns a specific value (see $DIS_TYPE) to the mesh node which is closest to the point with the name "gli_point_name")
  • POLYLINE gli_polyline_name (assigns specific values (see $DIS_TYPE) to the mesh nodes which are located along the polyline with the name "gli_polyline_name")
  • SURFACE gli_surface_name (assigns specific values (see $DIS_TYPE) to the mesh nodes which are located along on the surface with name "gli_surface_name") (TODO not benchmarked?)
  • VOLUME gli_volume_name (TODO not supported and not benchmarked?)
  • DOMAIN (assigns specific values (see $DIS_TYPE) to each mesh node of the whole model domain)
  • SUB_DOMAIN (TODO check)

Examples

1

#INITIAL_CONDITION
 $PCS_TYPE
 GROUNDWATER_FLOW
 $PRIMARY_VARIABLE
 HEAD
 $GEO_TYPE
 DOMAIN
 $DIS_TYPE
 CONSTANT 20.0
#STOP